tiny
02-05-2013, 11:52 PM
hi,
why does my machines y axis travel further than it should on the first cut and then misses the home point by the same amount its overcut. the second cut then starts from the new point and the whole job is wrecked.
l use mach 3 and vectric aspire.
thanks tiny
why does my machines y axis travel further than it should on the first cut and then misses the home point by the same amount its overcut. the second cut then starts from the new point and the whole job is wrecked.
l use mach 3 and vectric aspire.
thanks tiny