suesi34e
21-02-2014, 11:04 AM
Dear all,
I may ring Denford but I thought I would ask on here to see if anyone has hadsome firsthand experience.
I have a Denford Triac and am looking to buy some vices for it. I would like to have one big vice for holding a single job and two or preferably three for holding small parts that I would fit to a plate and mount the plate to the table. My concerns are I do not know what the table can take weight wise without overloading the machine. I have found the following size precision vices that are sized and weigh as follows:
W80mm Opening jaw 100mm Overall length 200mm weighs 5.6kg
W100mm Opening jaw 125mm Overall length 245mm weighs 10kg
They seem very heavy for a small table I guess if I was to use a large vice Icould run it the length of the table say so the moving jaw is to the right.
Any help here will be great, many thanks in advance
Suesi
I may ring Denford but I thought I would ask on here to see if anyone has hadsome firsthand experience.
I have a Denford Triac and am looking to buy some vices for it. I would like to have one big vice for holding a single job and two or preferably three for holding small parts that I would fit to a plate and mount the plate to the table. My concerns are I do not know what the table can take weight wise without overloading the machine. I have found the following size precision vices that are sized and weigh as follows:
W80mm Opening jaw 100mm Overall length 200mm weighs 5.6kg
W100mm Opening jaw 125mm Overall length 245mm weighs 10kg
They seem very heavy for a small table I guess if I was to use a large vice Icould run it the length of the table say so the moving jaw is to the right.
Any help here will be great, many thanks in advance
Suesi