mikem
03-11-2015, 11:08 PM
Hi Guy's I need some Help Please?
I'm having a problem with my Z Axis motor tuning . The settings are listed below. It goes in both directions when I use either of the Z+ or Z- tabs. Have any Ideas on what I'm doing wrong?
The wiring has been checked and double checked. I'm running the jog rate at 45% and it keeps going in one direction and then reverses the direction. If I run it at 100% it does nothing.
I listed the settings below
I'm using M542 drivers.
Motors
* Manufacturer Part Number: 23HS45-4204S
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 3.0Nm(425oz.in)
* Rated Current/phase: 4.2A
* Phase Resistance: 0.9ohms
* Inductance: 3.8mH+/-20%(1KHz)
BOB http://www.ebay.com/itm/Upgrade-Usb-...item2a4eceaf9b (http://www.ebay.com/itm/Upgrade-Usb-5-Axis-Cnc-Breakout-Board-Interface-Adapter-For-Stepper-Motor-Driver-/181710794651?hash=item2a4eceaf9b)
I'm having a problem with my Z Axis motor tuning . The settings are listed below. It goes in both directions when I use either of the Z+ or Z- tabs. Have any Ideas on what I'm doing wrong?
The wiring has been checked and double checked. I'm running the jog rate at 45% and it keeps going in one direction and then reverses the direction. If I run it at 100% it does nothing.
I listed the settings below
I'm using M542 drivers.
Motors
* Manufacturer Part Number: 23HS45-4204S
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 3.0Nm(425oz.in)
* Rated Current/phase: 4.2A
* Phase Resistance: 0.9ohms
* Inductance: 3.8mH+/-20%(1KHz)
BOB http://www.ebay.com/itm/Upgrade-Usb-...item2a4eceaf9b (http://www.ebay.com/itm/Upgrade-Usb-5-Axis-Cnc-Breakout-Board-Interface-Adapter-For-Stepper-Motor-Driver-/181710794651?hash=item2a4eceaf9b)