- Tab Content
- A_Camera's Activity
- About Me
- Video Library
-
Older Activity
-
2 Weeks AgoThe only thing you should consider when using a multimeter is that the aluminium frame is not a good conductor because of the surface oxide which...3 replies | 4428 view(s)
-
2 Weeks AgoYes, of course. You SHOULD connect the aluminium frame to ground. I suppose you mean PE as protective earth, not GND as in DC negative. The same is...3 replies | 4428 view(s)
-
2 Weeks AgoA_Camera replied to a thread Is a 600W AC servo better than a matching asyncrounous single phase AC motor? in Machine DiscussionYes, I know that, but normally the higher the power the higher the torque at the same speed. Also, the pulleys are as they are, the question was more...4 replies | 5587 view(s)
-
3 Weeks AgoA_Camera replied to a thread Is a 600W AC servo better than a matching asyncrounous single phase AC motor? in Machine DiscussionThank you. Yes, I am concerned about the power because I don't want to just drill, but also use hole saws of large sizes in thick steel. My current...4 replies | 5587 view(s)
-
3 Weeks AgoA_Camera started a thread Is a 600W AC servo better than a matching asyncrounous single phase AC motor? in Machine DiscussionTypically, a servo motor has 30%-60% higher torque capacity and 30% better torque utilization with faster acceleration and deceleration, compared to...4 replies | 5587 view(s)
-
3 Weeks AgoI decided to make an upgrade (actually more than one...) of my CNA lathe. Number one update is to change the spindle motor. While the...33 replies | 54602 view(s)
Statistics
Total Posts
- Total Posts
- 694
- Posts Per Day
- 0.24
- Last Post
- Grounding the machine, electrics 2 Weeks Ago
Total Thanks
- Total Thanks
- 36
General Information
- Last Activity
- 3 Days Ago
- Join Date
- 13-05-2016
metalworking pillar drill...