-
28-12-2016 #1
I'm tempted to address some noise issues I'm experiencing (random e-Stops, and the like) with a bit of a re-jig of the mill set-up (mill is Mach-3 adapted Denford Starmill) - new support table, and integrated control system. As part of this I'm looking at the cheaper end of the motion controllers, and that old stalwart of CNC supplies, eBay, offers a 3-axis Novusun, "NVEM V1.1" at an affordable price-point.
My question is: has anyone here had experience (either good or bad) of this breed of motion controllers?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CSLAB CSMIO/IP-M 4-axis Ethernet Motion Controller
By dudz in forum CS-Lab (CSMIO)Replies: 35Last Post: 02-01-2017, 01:27 AM -
any one bought one of these £100 ethernet 200khz controllers
By nobby in forum General DiscussionReplies: 12Last Post: 05-06-2016, 09:45 PM -
Comparing motion controllers...
By JW1977 in forum Control Hardware & SystemsReplies: 34Last Post: 17-02-2016, 02:36 PM -
PCI Motion Controllers
By IanS1 in forum Motor Drivers & ControllersReplies: 0Last Post: 16-05-2013, 12:13 AM -
USB and Ethernet Mach3 motion controller PLCM-E3
By Purelogic R&D in forum Manufacturer NewsReplies: 39Last Post: 29-12-2012, 09:38 AM
Bookmarks