Threaded View
-
15-11-2017 #1
ON HOLD - We are evaluating if we can manufacture these ourselves or not. Will open up for quotes again soon if we can't.
All files located in .zip bellow.
50x Top and Bottom
AIO top.stl
AIO bottom.stl
90degree angles can be milled with 3mm bit.
Curved bit at the top can be stepped at 0.1mm using 3mm bit. Yes 3mm floor is fine.
3 square holes can be milled with 2mm bit on the 90 degree corners.
1mm chamfer required on rear side around the edges and 3 holes.
The 4 pillars are actually a drill hole size of 2.5mm not 1.6mm, will update later.
75x Top and Bottom
RP top.stl
RP bottom.stl
3 square and large rectangle holes can be milled with 2mm bit on the 90 degree corners.
1mm chamfer required on rear side around the edges and 3 holes and large rectangle hole.
The 2 pillars and other 1.6mm hole are actually a drill hole size of 2.5mm not 1.6mm, will update later.
35x Top and Bottom
S top.stl
S bottom.stl
90degree angles can be milled with 3mm bit.
3 square holes can be milled with 2mm bit on the 90 degree corners.
1mm chamfer required on rear side around the edges.
If you have the ability to tap on machine, all 2.5mm holes can be tapped M3, rear large hole on bottom parts is 1/4-20.
I can do the tapping if it adds to the cost too much.
https://drive.google.com/open?id=1F7...YyKvIIJk2HwR31Last edited by JOGARA; 01-12-2017 at 11:42 AM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Machine cases and covers for 3D Printers
By Protopro in forum Manufacturer NewsReplies: 0Last Post: 01-11-2017, 08:59 PM -
RFQ: Small run of parts in aluminium
By CHudson in forum Projects, Jobs & RequestsReplies: 0Last Post: 06-10-2017, 04:12 PM -
angular contact bearings - back to back, further apart
By dsc in forum Linear & Rotary MotionReplies: 16Last Post: 05-01-2014, 10:59 PM -
RFQ: 2 x Headphone Amp cases machined from Walnut.
By SamW in forum Projects, Jobs & RequestsReplies: 8Last Post: 20-04-2013, 09:03 AM -
Drivers,BOB and PSU are in a PC case, do i earth the case
By deannos in forum Motor Drivers & ControllersReplies: 4Last Post: 27-11-2011, 03:43 PM
Bookmarks