Thread: SBR20LUU seal interference
Threaded View
-
19-07-2019 #1
Rebuilding laser cutters Y axis.
Bought 20mm supported round rail and a bearing block with 2 cartridges in it.
The motion is being restricted by rubber seals rubbing against the rail.
Axis at the moment is driven by nema17 motor and that kind of interference may impact motion.
Can i remove the side seals off of the block ? Or at least trim them back a bit ?
Or is it just my inner idiot speaking ?
Bearings were cheap, can always replace, just wondering by how much would it impact running it in smoky environment with occasional manual wipedown of the rail.... Dont want to destroy the only one i got at the moment.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Spindle Interference
By Pointy in forum General ElectronicsReplies: 5Last Post: 04-08-2016, 10:07 AM -
VFD interference problem
By eurikain in forum General ElectronicsReplies: 81Last Post: 20-03-2016, 11:20 PM -
Noise, Interference, and unexplained electrical behaviour
By g4ghp in forum General ElectronicsReplies: 4Last Post: 24-04-2014, 11:39 AM -
Bearing interference fit / press fit
By Mad Professor in forum General DiscussionReplies: 5Last Post: 30-09-2012, 11:26 PM -
19inch Rack Enclosure - interference?
By Washout in forum General ElectronicsReplies: 12Last Post: 22-09-2012, 09:10 PM
Bookmarks