-
12-10-2019 #11
-
13-10-2019 #12
I would guess that is a quadrature output incremental encoder, however searches have not found any manuals for a 755 encoder.
How many wires does it have?
Ideally you want encoders with differential outputs, which means you're looking at a minimum of 6 wires (+V, Gnd, A-, A+, B-, B+), plus possibly an index pulse (Z-, Z+).
Everything has the potential for failure, but provided you're willing to learn, then most things are possible.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
13-10-2019 #13
-
24-10-2019 #14
Hey Welcome to the Rye club from New Zealand!
Here is my Rye MG3000 which we acquired about a year ago. I am currently doing a full rebuild and retrofit of the control systems, moving to a DSPMC/IP, keeping the original Servo amplifiers and Tachometers in place. There is a lot of work in it!
Hope all goes well with your machine they are quite rare!
-
26-10-2019 #15
-
29-10-2019 #16
Today I worked on some stuff mainly for safety;
- plaque to allow the motor to sit perfectly flush on the Cnc frame (there is a 2mm step on the moto housing)
- cover for the power supply, so that the risk of touching the 220v cable is lower;
- case for the BOB (not my design)
I’ve also made a mask so that the new motors will be perfectly centered respect the old motors.
Last edited by agors; 09-10-2020 at 02:54 PM.
-
03-11-2019 #17
More things done, soon other updates
Last edited by agors; 09-10-2020 at 02:53 PM.
-
11-12-2019 #18
machine perfectly running thanks to a colleague
Last edited by agors; 09-10-2020 at 02:52 PM.
-
26-12-2021 #19
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: Finished builds picture menu
By routercnc in forum DIY Router Build LogsReplies: 9Last Post: 05-12-2021, 12:28 PM -
NEW MEMBER: New member AGORS
By agors in forum New Member IntroductionsReplies: 2Last Post: 10-10-2019, 09:50 PM -
picture conversion to DFX/ Gcode. Help required please.
By Gasgasbones in forum Programmers CornerReplies: 17Last Post: 19-12-2014, 11:42 AM -
Microcarve picture carving software
By cnctoybox in forum CAD & CAM SoftwareReplies: 0Last Post: 26-03-2012, 07:00 PM -
Router/Spindle choice for Makita laminate trimmer upgrade
By CraftyGeek in forum Makita Routers & TrimmersReplies: 7Last Post: 30-11-2009, 11:23 AM
Bookmarks