Thread: Which wire goes where
-
29-04-2020 #1
-
29-04-2020 #2
Just an update, I found some information on the web. And wired the U,V,W terminals to the spindle block pins.1,2,3. Start the power and the spindle sounds like it is spinning up, but it’s not turning at all. Any ideas out there
-
29-04-2020 #3
Do not power up the motor unless you sure that you connected it properly and set drive parameters correctly :)
-
29-04-2020 #4
Do you have a multimeter that can measure resistance?
You should be able to check between pairs of contacts, hopefully you will find 3 pairs with a similar resistance, the 3 coils of the motor. One of the other contacts could of an earth, which could be connected to the body of the motor.
-
29-04-2020 #5
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Wire EDM machine
By Neale in forum Other Machines & BuildingReplies: 36Last Post: 05-11-2018, 09:31 AM -
Wire diagram
By Raymond in forum Lathes, Lathe Rebuilding & ConversionsReplies: 0Last Post: 11-06-2014, 06:24 PM -
CNC hot wire cutter
By Nstocks in forum Machine DiscussionReplies: 0Last Post: 22-05-2014, 07:54 PM -
How to Wire this Sensor
By manofgresley in forum General ElectronicsReplies: 1Last Post: 26-11-2013, 05:09 PM -
Wire.. Oh why so many types....
By BedlamRik in forum General ElectronicsReplies: 5Last Post: 05-01-2013, 01:05 AM
Bookmarks