-
04-02-2021 #1
Hi,I got my chineese plasma a week ago and i am still struggling with the machine.Here is my problem:
After first cut is finished, the torch dives, the arc voltage
increases and the height control lowers the torch in an attempt
to correct the high voltage.After this ussualy shows error
"Collision" or "High arc voltage"
and this is happenning always, on every cut.
I tried to cut with no Leadout and it happens again, i reduced "Time between close thc and close arc" in cotroller settings but still nothing changes.
Controller is cc-s4c, thc is XPTHC-400-PT , plasma cutter is LGK-120A.
Any suggestions where the problem might be ?
Thanks !
-
05-02-2021 #2
Not familiar with the control at all but just wondering if the THC itself has an anti-dive function that needs adjusting?
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Torch Height control
By Bobp in forum General ElectronicsReplies: 21Last Post: 09-12-2019, 04:46 PM -
Plasma Torch height setup required
By Yorkshirerapper in forum Artsoft Mach (3 & 4)Replies: 0Last Post: 08-11-2017, 03:26 PM -
Proma elektronika torch height controler any good
By whensparksfly in forum General ElectronicsReplies: 3Last Post: 06-03-2016, 01:17 AM -
TD torch cut height enquiry
By marbles in forum Plasma Table MachinesReplies: 0Last Post: 19-02-2016, 11:57 AM -
FOR SALE: 3 sets of 4 xl pulleys and a plasma machine torch
By nobby in forum Items For SaleReplies: 0Last Post: 20-05-2014, 07:33 PM
Bookmarks