Novamill - Mach3

[m_c]

There's no reason they can't, if they've been re-wired.

For the size/power of a Novamill, you can probably get away with using the limit switches just for homing, then relying on soft limits.
It's not like a Novamill axes have enough power to do any damage if you run into the end of the physical travel.

[Deck36]

I noticed they aren't the strongest when they just keep going if I hit the hard end stop.

Looks like I have some fixing to do. In the meantime I've managed to get all the axes to jog and found the pins/port combination to get the spindle to run, but I have no control over it.
Keep getting the PWM bumped to minimum warning even when I enter big numbers.
Any clues on how I get control? The screen overrides won't work but I can start it from there or the F5 key.