Thread: wiring up my motors
-
05-01-2010 #1
Hello, i'm just playing about with one of those cheap tb6560 4 axis driver boards from china,
nothings gone pop yet wich is good but also nothing is happening apart from buzzing from the motors
i was hoping one of you could give me your opinion on how these should be wired
the axis conections on the board are marked> a+ a- b+ b-
heres the diagram for the motors
i was trying to wire them up bi-polar parallel
cheers for any thoughts
-
05-01-2010 #2
well if you followed the colour codings correctly then they should work.
The next thing is are the motors locked...i.e. you cant turn the spindle.. if thats so then the motors are powered so the problem is its not getting step commands...
What power supply and current settings are you using?
-
05-01-2010 #3
so then would i wire the blk and the org/wht to a+ and the blk/wht and org to a-??
and no i can't turn the spindles
i have just realized my port address may not be normal as it is an expansion card.
now i've just got to try and work out how to find my ports real address?????
-
06-01-2010 #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
wiring
By uppy121 in forum General ElectronicsReplies: 4Last Post: 02-04-2013, 06:52 PM -
Help wiring M60STH88-3008DF Steppers Motors to 752 Drivers
By Mad Professor in forum Stepper & Servo MotorsReplies: 12Last Post: 01-09-2011, 10:09 AM -
wiring help
By deannos in forum Motor Drivers & ControllersReplies: 3Last Post: 08-06-2011, 02:20 PM -
help me for wiring
By ali hedi in forum General ElectronicsReplies: 0Last Post: 28-11-2010, 01:20 PM -
wiring help
By ste68blue in forum Stepper & Servo MotorsReplies: 6Last Post: 29-07-2009, 10:23 AM
Bookmarks