Thread: Taking this route for spindle
Threaded View
-
24-08-2010 #1
I'm looking to use this senario of spindle drive rather than conventional kress/water cooled spindle.
It will use the (ER) type chucks and collets which will multiply the use of different bits rather than only have a limited tooling option using a kress ect,ect.
I have a brushless motor at hand,in the process of making a pully for the motor but don't know what size (ER) chuck to go for yet?
Whats the pros and cons of this type of set up? :tup:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Chinese 300W DC spindle - is the spindle shaft grounded?
By HankMcSpank in forum Spindles & Drive MotorsReplies: 44Last Post: 26-11-2016, 07:25 PM -
BUILD LOG: taking the back off a stepper
By blackburn mark in forum DIY Router Build LogsReplies: 10Last Post: 06-10-2012, 08:12 PM -
this site is taking a long time load or refresh pages
By deannos in forum General DiscussionReplies: 6Last Post: 15-12-2011, 10:00 PM -
WANTED: Taking the plunge again!!!
By Ricardoco in forum Items WantedReplies: 33Last Post: 26-08-2011, 10:50 AM -
Taking the plunge
By Robin Hewitt in forum Computer SoftwareReplies: 0Last Post: 14-05-2010, 01:22 AM
Bookmarks