Thread: Total novice and lost
Hybrid View
-
03-09-2010 #1
Hello to all,
Having recently purchased a second hand cnc router the bits and pieces arrived by courier today.
Less than impressed by the state of the machine as bolts had worked there way loose etc in transit.
Attached are some images of the router but the main question I have is how do I connect the controller to the pc. The controller has a male connector and my pc also has a male connector.
Any help would be apprecited.
-
03-09-2010 #2
Sounds like you might need a gender changer for the parallel port lead:
http://www.diskdepot.co.uk/acatalog/...BELKIN_2d01592
When you get going you might one some of these to tidy up the wiring:
http://cgi.ebay.co.uk/IGUS-ENERGY-CH...item4cf15bdf7d
Good luck with it all
-
03-09-2010 #3
Never seen a PC with a male Parallel port.
If it has holes in it then it's female, if it has sticky out pins than it's male.
Biology 101.John S -
-
03-09-2010 #4
You quite right, my pc is female and the controller is male. I guess I need to get a cable that is female/male?
-
03-09-2010 #5
Yes, but make sure it is wired 1:1 and is not a serial cable. Something like this available in 1.5 to 10m lengths
-
03-09-2010 #6
Snap, thats just what I was looking at!
-
03-09-2010 #7
Or this one £2.86 plus vat.
http://uk.rs-online.com/web/search/s...duct&R=0480541John S -
-
04-09-2010 #8
Gents,
Can anyone advise on how I connect the power supply as shown on the first photos? I assume that I need a fused plug and lead connected to the L, N and Earth thus providing 240v inout but which terminals do I then connect the L, N and Earth of the control unit as shown?
I thought all if this would have come assembled from the gent I purchased from but alas not!
Thanks to all in advance.
PS, I have now ordered a cable as suggested.
-
04-09-2010 #9
The photo's are not big enough or clear enough for anyone to help you safely.
John S -
-
04-09-2010 #10
Thread Information
Users Browsing this Thread
There are currently 6 users browsing this thread. (0 members and 6 guests)
Similar Threads
-
NEW MEMBER: From Oz - ex of Cardiff anf lost :P
By Carlb1058 in forum New Member IntroductionsReplies: 6Last Post: 02-04-2013, 04:57 AM -
NEW MEMBER: Hello - total newbie!
By eggsBenedict in forum New Member IntroductionsReplies: 15Last Post: 05-01-2013, 12:47 AM -
NEW MEMBER: Total noob about to embark on a build.
By Wal in forum New Member IntroductionsReplies: 6Last Post: 21-12-2012, 02:48 AM -
NEW MEMBER: Hello everyone. Total newbie here. Where do I begin?
By DarkWalkJRB in forum New Member IntroductionsReplies: 2Last Post: 07-02-2012, 08:31 PM -
Total novice seeks advice on stepper motor drivers
By R.Andersen in forum Motor Drivers & ControllersReplies: 1Last Post: 25-01-2012, 11:34 AM
Bookmarks