Thread: Which stepper driver
-
25-09-2010 #1
I was looking at stepper drivers ay diycnc http://www.diycnc.co.uk/html/driver50.html and the kinko http://www.slidesandballscrews.com/2...ml?cPath=44_97
The literature says that the kinco tunes to the motors, whats that all about.
Where the spec says 24 to 70 volts, is the voltage used matched with the motor used?
Anyone used these drivers?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
Stepper Driver requirements?
By Dwayne Dibbley in forum Motor Drivers & ControllersReplies: 3Last Post: 24-07-2013, 05:29 PM -
stepper driver tester
By ptjw7uk in forum Motor Drivers & ControllersReplies: 2Last Post: 24-06-2013, 05:48 PM -
best stepper driver???????
By Ross77 in forum Motor Drivers & ControllersReplies: 37Last Post: 21-04-2013, 05:05 PM -
connecting stepper driver to PC
By berkut in forum General ElectronicsReplies: 2Last Post: 10-06-2009, 09:25 PM
Bookmarks