Thread: PCI parallel card / BOB
Threaded View
-
29-01-2012 #1
I have a small niggle with my newly built machine. The PC is built into the machine housing itself so it's a complete unit. When I press the PC on button the BOB is closing the spindle relay, making the spindle spin until I enter EMC2.
Is there anyway that a PCI card can be configured so at not to send out a signal during the boot sequence? I thought about inverting the relay contacts & BOB output, but that would make the spindle start as soon as I plug the machine into the wall. I know I could rewire the spindle to take power from the seperately switched motor drives but i was wanting to keep each system individually fused.
Many thanks,
Gavin
Thread Information
Users Browsing this Thread
There are currently 5 users browsing this thread. (0 members and 5 guests)
Similar Threads
-
Fix engrave vertical gap or Upgrading laser cutter control card Leetro MPC6515 ?
By Paul Shroom in forum Machine DiscussionReplies: 3Last Post: 18-05-2014, 03:40 AM -
Steppers, Series, Parallel
By Ricardoco in forum Stepper & Servo MotorsReplies: 14Last Post: 12-01-2013, 08:28 PM -
Parallel PCI Card Experience
By andy0202 in forum Computer HardwareReplies: 11Last Post: 24-08-2012, 10:39 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM -
Controller card selection
By Hogout in forum Motor Drivers & ControllersReplies: 7Last Post: 14-05-2009, 11:26 PM
Bookmarks