Thread: Spindle Motor Recommendation.
Threaded View
-
21-11-2013 #1
Hello all,
I am at the point where I need to buy a spindle motor for my CNC router project.
I bought the linear rails and ball screws from Chai and wasn't impressed by the experience.
The packing was poor and one of the rails was quite badly bent. He will not ship a replacement unless I buy more stuff
which to me is throwing good money after bad. So this has left me slightly sceptical about going down the Chinese route again.
I have seen the following on Arc Euro Trade's site:
ER20 High Speed Spindle - 1.1kW (1.48HP) - 24000rpm
High Speed Spindles, Motors & Inverters - Arc Euro Trade
Has anyone out there bought this particular motor and would they do it again?
Thanks in advance for any help on this.
Neil.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
Router recommendation for University
By S2L in forum Marketplace DiscussionReplies: 12Last Post: 05-12-2012, 11:58 AM -
Router bit recommendation, spindle speed and feed rate?
By FlightCaseCo in forum Spindles & Drive MotorsReplies: 13Last Post: 03-04-2012, 12:53 PM -
Spindle Motor
By pdl in forum Stepper & Servo MotorsReplies: 0Last Post: 09-08-2011, 10:56 AM -
servo motor as spindle motor
By Scott in forum General DiscussionReplies: 1Last Post: 03-10-2010, 06:42 PM
Bookmarks