Hybrid View
-
11-06-2014 #1
My first attempt at this question turned into a shapeless ramble, so to be more specific...
I am aware that there are various tradeoffs around the use of microstepping. In practice, is there any point in going to more than, say, 800 steps/rev?Last edited by Neale; 12-06-2014 at 11:19 AM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Advice please! JAF Motion Controller issues!
By Mark Chard in forum Machine Control SoftwareReplies: 0Last Post: 31-01-2014, 05:03 PM -
CNC Motion control
By StoneyCNC in forum Manufacturer NewsReplies: 1Last Post: 26-08-2013, 10:07 AM -
Design issues with linear motion...
By rob_colby in forum General DiscussionReplies: 3Last Post: 05-01-2011, 12:13 AM -
Time for a purpose built motion control computer.
By GeoffV in forum General ComputingReplies: 17Last Post: 08-11-2010, 01:11 AM -
Motion Control drivers and motors
By bruce_miranda in forum Motor Drivers & ControllersReplies: 71Last Post: 27-08-2009, 09:40 AM
Bookmarks