-
29-10-2014 #1
I've just made a similar version edge finder to that of the maker masters project by bill Briggs
my question is, how do we wire these things up to the BOB
-
29-10-2014 #2
-
29-10-2014 #3
Oh I see thanks for that. Would the ground be the tool and the plus the edge finder?
sorry here is the link http://www.themakersguide.com/home/p...-edge-finder-2
-
29-10-2014 #4
Most of all depends of your exact BOB. Whats yours? Usually on pin 13 directly if you have pull up resistor there. http://www.autoleveller.co.uk/cnc-probe-guide/
-
The Following User Says Thank You to Boyan Silyavski For This Useful Post:
-
30-10-2014 #5
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
-
30-10-2014 #6
I'm using the uniport
-
30-10-2014 #7
just reading your linksilyavski, is the resistor needed in my application?
-
30-10-2014 #8
-
30-10-2014 #9
you know, i keep forgetting to read that damn manual! guess i just like testing you guys haha
-
30-10-2014 #10
Uniport works fine straight from the inputs I used one for 2yrs until it gave up the ghost. My famous Rupert Egg touch probe video was using the uniport.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Torch Height control
By Bobp in forum General ElectronicsReplies: 21Last Post: 09-12-2019, 04:46 PM -
uPVC CNC Corner Cleaner
By StuH in forum Machine DiscussionReplies: 2Last Post: 20-07-2013, 12:09 AM -
1/4" / 6mm edge finder?
By jcb121 in forum Marketplace DiscussionReplies: 0Last Post: 18-03-2013, 02:58 PM -
Driver wiring to my computer for mach3 to control
By AdCNC in forum Motor Drivers & ControllersReplies: 13Last Post: 01-04-2010, 12:27 AM -
Electronic edge finder: how do they work?
By irving2008 in forum Probing, Digitizing & ScaningReplies: 14Last Post: 29-08-2009, 10:25 PM
Bookmarks