Hybrid View
-
31-07-2015 #1
looking at replacing my sem servo motor with something like this
http://www.ebay.co.uk/itm/3KW-WATER-...item2a52124388
as my machine has an ATC I need to get a pulley attached to the end of the spindle.
the plan would be to mod and existing pulley rather than make a new one, so question is where do I find thread details of an ER20?
many thanks
-
Is this what you are looking for http://www.amazon.com/Dorian-Tool-ER.../dp/B00CB0Y7SI M25 x 1.5 Thread ..Clive
..Clive
The more you know, The better you know, How little you know
-
The Following User Says Thank You to Clive S For This Useful Post:
-
31-07-2015 #3
perfect many thanks
-
Andy Are you sure the spindle you linked to will do the job as they don't have any torque at low speeds say lower than about 3.5K rpm not like a servo ..Clive
..Clive
The more you know, The better you know, How little you know
-
31-07-2015 #5
well...
I have a denford triac, its got a sem MT30U4 servo motor -
http://igor.chudov.com/projects/Brid...ata_Manual.pdf
although a very good motor with lots of torque it only does 4000rpm, so my feed rates are really slow. but yes I can do a 2mm deep cut in ally with an 8mm cutter, or a 1mm deep cut in ally with a 20mm cutter without any trouble.
what I was thinking was to get one of these Chinese spindles, swap the bearings out on my mill so they can handle the speed and do a 2:1 reduction. so id be looking at 12000rpm. so I would gain a bit more torque.
I don't actually need to run the spindle at slow speeds, I use threadmills for tapping etc...
-
Ok I was wondering if you needed position control on the spindle for the atc. That's not so easy on the spindle you linked too.. ..Clive
..Clive
The more you know, The better you know, How little you know
-
03-11-2015 #7
-
03-11-2015 #8
to little info on the Chinese spindles so ive not done it
-
03-11-2015 #9
-
The Following User Says Thank You to Chaz For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Denford Triac VMC
By fidia in forum Milling Machines, Builds & ConversionsReplies: 6Last Post: 19-08-2016, 08:18 AM -
FOR SALE: ER20 DIY Spindle Parts
By Mad Professor in forum Items For SaleReplies: 1Last Post: 03-11-2012, 06:51 PM -
Conversion of ER16 spindle to ER20
By Tenson in forum General DiscussionReplies: 3Last Post: 14-07-2012, 05:19 PM -
Chinese vfd/spindle question
By Shinobiwan in forum Tool & Tooling TechnologyReplies: 2Last Post: 02-03-2012, 02:02 AM -
Denford Triac Spindle Fault
By Sam_Smith in forum Denford MillsReplies: 5Last Post: 04-05-2011, 11:07 PM
Bookmarks