Quote Originally Posted by Nemo1966 View Post
Anyhoot with a lot of help (thanks to joe.average and Andrew over at the Warp9 forum). I have managed to sort out the wiring in theory. However the manual states the pins numbers but not how they relate to the actual connection on the unit. The connection looks like an SCSI 36 pin.
I'm not quite sure what you are asking here.? You say how they relate to the connection on the Unit.? What unit are you talking about.? Do you mean the Controller or breakout board if so then you don't say which controller or breakout board and without that, no one can help you really?

The diagram of the pinout for the drive is self-explanatory really, you decide which of the pins you are going to use and connect to the pin numbers on the 36-pin connector. Then at the other end, you have the choice to wire to the same pin numbers if it's 36pins or if the controller or bob has its own pin numbers on say a 44 pin connector then you wire to the relevant pins this requires. Often on the connector at the other end, you will pull each pin wire and send it to several places inside the control box.

We need more info on the "Unit" you talk about.