Panasonic MSD043Axxx Servo Driver pin outs????

[dazp1976]

The diagram of the pinout for the drive is self-explanatory really, you decide which of the pins you are going to use and connect to the pin numbers on the 36-pin connector. Then at the other end, you have the choice to wire to the same pin numbers if it's 36pins or if the controller or bob has its own pin numbers on say a 44 pin connector then you wire to the relevant pins this requires. Often on the connector at the other end, you will pull each pin wire and send it to several places inside the control box.
We need more info on the "Unit" you talk about.

A bit like this one which is a db44 for a delta.
https://www.aliexpress.com/item/1005...c00PlsAmK&mp=1
The loose ends get connected to the relevant pins on your breakout/controller you want to use to control it.



Looks like a 36pin scsi on the panny to me.

Something like this and chop it to loose one end (depending on whether need male/female).
https://www.aliexpress.com/item/4001...Adapt=Pc2Msite
Or solder your own 'kit' connector together.
https://www.aliexpress.com/item/3304...Adapt=Pc2Msite

[Nemo1966]

A bit like this one which is a db44 for a delta.
https://www.aliexpress.com/item/1005...c00PlsAmK&mp=1
The loose ends get connected to the relevant pins on your breakout/controller you want to use to control it.

Looks like a 36pin scsi on the panny to me.

It's the scsi 36 pin on the actual drive i need to know about.

[Nemo1966]

In short... is this correct or not?????

Attachment 31027

[dazp1976]

In short... is this correct or not?????

Attachment 31027

The attachment not working for me.
I added a couple of examples in my previous post.
I don't know whether you'd need male/female.
You'll have to judge it against your drive CN connection.
Likely to find something on Aliexpress (if your not in a rush).

[JAZZCNC]

Ok, can you post the manual or a link to it.