Diy concrete cnc

[masinecc]

Sure... It's not epoxy resin. It's structural concrete with internal steel reinforcements (the same concrete used in bridges, etc).
So far so good.

What min and max sand size ?

[XYZ_Spec]

What min and max sand size ?

It's already done for you inside the bags.
Pre-mixed, just have to add water

[Lee Roberts]

Hi Lee, thanks...
All the parts were made by this machine. It has evolved over the last year... It all started with a 3018 from aliexpress lol

Understood, I went on to watch the vids after I posted, looks good :)

It's already done for you inside the bags.
Pre-mixed, just have to add water

Still what one did you use the finish looks really smooth, any tricks to that ?

[XYZ_Spec]

Still what one did you use the finish looks really smooth, any tricks to that ?

The mix is done with fine sand, that's why the finish is not rough. Applied primer, sanded a bit and then painted it. It's not that perfect, but the performance is what matters at the end. :)

[masinecc]

It's already done for you inside the bags.
Pre-mixed, just have to add water

Lucky you. Pms share the name on the mix, i wanna see the technical data sheet and see what i can find close to it locally

[XYZ_Spec]

Lucky you. Pms share the name on the mix, i wanna see the technical data sheet and see what i can find close to it locally

Here it is the manufacturers site page for this product I've used.
It seems to be only available in Portuguese language.
This is the best I can do for you.

https://www.cimpor.com/-/betao-seco-be-30

[Lee Roberts]

Lucky you. Pms share the name on the mix, i wanna see the technical data sheet and see what i can find close to it locally

Same...

Here it is the manufacturers site page for this product I've used.
It seems to be only available in Portuguese language.
This is the best I can do for you.

https://www.cimpor.com/-/betao-seco-be-30

Thanks for sharing...

What about this probe, how you finding it, accuracy etc?

https://youtube.com/shortsNtOfxCaf4lU

P.S Is it still v6: 3D Touch Probe Edge Finder ???

[XYZ_Spec]

What about this probe, how you finding it, accuracy etc?

https://youtube.com/shortsNtOfxCaf4lU

P.S Is it still v6: 3D Touch Probe Edge Finder ???

Yes Lee, V6.
I like it a lot, and it's not crazy expensive.
I want to install it permanently onto the spindle mount, this will allow me to set zero without having to do a tool change.